Pass Labs XA200 Manual do Utilizador

1XA200 Owner’s ManualpassTMXA200 Owner’s ManualMay 18, 2006

10XA200 Owner’s ManualPlease check with the factory-authorized distributor in the country you are purchasing this product for specific warranty inform

11XA200 Owner’s ManualWater and moisture: Electrical devices should not be used near water ( as per example, near a bathtub, washbasin, kitchen sink,

12XA200 Owner’s ManualSometimes two designs complement each other so well that you are surprised when you learn they weren’t invented together.

13XA200 Owner’s Manualthey vanish at the output, typically by a factor of 10 or so for matched single-ended Class A circuits. Supersymmetry™ extends

14XA200 Owner’s ManualThe amplier has only the two stages, an input stage of a balanced pair of input devices, and the output stage, a balanced pair

2XA200 Owner’s ManualAnalog designer Nelson Pass has over the years produced some truly great solid-state ampliers, each unique in it’s own way. Not

3XA200 Owner’s ManualThe XA200 has a massive toroidal transformer coupled to a high current DC reservoir. Recognizing that the XA200’s abili

4XA200 Owner’s Manualdard 15 amp IEC receptacle at the rear of the amplier chassis. Two XA200’s may be run on a single 15-amp circuit. T

5XA200 Owner’s Manualcharged. The “Power” LED should not be on. If the “Power” LED is on, don’t get excited, just use the front panel stand-by butt

6XA200 Owner’s ManualNow that the source component is connected, make sure there is no signal coming from it, probably by turning the volume

7XA200 Owner’s ManualYou may remotely operate the stand-by mode by applying 12 volts DC to the single pair of 5 way connectors on the rear of the am

8XA200 Owner’s Manualing without excessive force is plenty. Cleaning contact surfaces with one of the commercially available electronic contact clean

9XA200 Owner’s ManualAll figures obtained after 1 hour warm-up, with regulated 120 VAC power line. See manual notes about AC power line regulation.Ga